Final Gear Case Separation; Gear Tooth Contact Pattern Check; Right Ring Gear Shims - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:

Table of Contents

A (thinnest): 1.82 mm (0.072 in)

D (standard): 2.00 mm (0.079 in)

I (thickest): 2.30 mm (0.091 in)

For ring gear shim replacement, see page 12-12.

FINAL GEAR CASE SEPARATION

Loosen the eight cover bolts in a crisscross pattern

in two or three steps and remove them.

Pry the cover at the prying points using a screw-

driver and remove the case cover.

Check the ring gear needle bearing in the gear case

for wear or damage.

GEAR TOOTH CONTACT PATTERN

Clean the sealing material off the mating surfaces of

Keep dust and dirt

the gear case and cover, being careful not to dam-

out of the case and

Apply a thin coat of Prussian Blue to the pinion gear

teeth for the tooth contact pattern check.

pply Prussian Blue