BRAKE SYSTEM (ABS)
Remove the sensor wire from the clamps and clips.
Remove the two bolts, clamp and speed sensor.
Installation is in the reverse order of removal.
Route the wire
properly
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
(page 1-23).
After installation, check the air gap (page 16-29).
REAR SENSOR
Remove the following:
– right saddle bag (page 2-15)
– fuel tank (page 5-56)
Disconnect the sensor 2P (gray) connector.
Remove the sensor wire from the clamps and clips.
Remove the two bolts and the speed sensor.
Installation is in the reverse order of removal.
Route the wire
properly
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
(page 1-23).
After installation, check the air gap (page 16-29).
16-30