Saddlebags; Saddlebag Catch - Honda GL1800 Service Manual

SADDLEBAGS

Perform the following procedure for both the left
and right saddlebags.
Remove the following:
– seat (page 2-5)
– left and right side covers (page 2-5)
– rear fender A (page 2-13)
– trunk lower cover (page 2-13)
– trunk lock cover (page 2-13)
Disconnect the saddlebag opener cable and sub-
wire harness connectors.
Remove the four bolts, washer and the saddlebag.
Remove the four collars from the saddle bag.
Installation is in the reverse order of removal.
Route the wires
and cables properly
(page 1-23).

SADDLEBAG CATCH

Perform the following procedure for both the left
and right saddlebags.
Remove the saddlebag.
The saddlebag
Remove the ten screws and inner cover.
catches are located
Disconnect the saddlebag open switch connector
on the inside top of
and remove the saddlebag catch assembly.
the saddlebags.
PENER CABLE
WASHER
B LTS
C LLARS
FRAME/BODY PANELS/EXHAUST SYSTEM
SADDLEBAG
SADDLEBAG CATCH
ASSEMBLY
COVER
SCREWS
C NNECT RS
CONNECTOR
2-15