Rear Crankcase Cover Removal - Honda GL1800 Service Manual

Install the two dowel pins.
Install the slave cylinder and tighten the three bolts.
Release the clutch lever from the handlebar.
Install the EVAP canister (page 5-74).
Fill the crankcase with the recommended engine oil
(page 3-11).

REAR CRANKCASE COVER REMOVAL

Remove the following:
– engine (section 7)
– reverse shift arm/cables (page 19-42)
– starter/reverse motor (page 19-17)
– alternator (page 17-10)
– water pump (page 6-17)
– clutch outer (page 9-20)
Remove the three bolts and the output shaft bearing
holder.
Remove the O-ring and oil seal.
Unstake the lock nut with a drill or grinder.
Be careful that
metal particles do
not enter the
bearing and that the
output shaft
threads are not
damaged.
Hold the output shaft and loosen the lock nut, using
the special tools and breaker bar.
TOOLS:
Shaft holder
Lock nut wrench, 30 x 64 mm
Remove the lock nut and discard it.
GEARSHIFT LINKAGE/TRANSMISSION
07PAB-0010200 or
079249-PJ40001
(U.S.A. only)
07916-MB00002 or
07916-MB00001
EARING HOLDER
OCK NUT
Unstake
OCK NUT WRENCH
SHAFT HO DER
10-11