Cable Stay/Map Sensor - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:

Table of Contents

FUEL SYSTEM (Programmed Fuel Injection)

CABLE STAY/MAP SENSOR

Remove the two screws and cable stay.

Remove the two screws, MAP sensor and O-ring.

Install the cable stay and tighten the screws.

TORQUE: 4 N·m (0.4 kgf·m, 2.9 lbf·ft)

Install a new O-ring into the throttle body groove.

Install the MAP sensor and tighten the screws.

TORQUE: 2 N·m (0.2 kgf·m, 1.4 lbf·ft)

INSTALLATION

Make sure the insulators and bands are installed

properly as shown.

Connect the throttle cables to the throttle drum and

install them onto the cable stay.

Screw in the throttle cable end bolts fully and

tighten them.

Connect the cruise actuator cable to the actuator

drum and install it onto the cable stay.

Adjust the cable position with the nuts so that the

distance between the cable cap screw end and stay

is 34 mm (1.34 in) as shown.

THROTTLE C BLES

CTU TOR DRUM

THROTTLE DRUM