Secondary Master Cylinder Assembly - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:

Table of Contents

BRAKE SYSTEM (Standard)

Coat the master piston and piston cups with clean

Do not allow the

brake fluid.

piston cup lips to

Install the primary cup onto the spring.

turn inside out.

Install the spring and master piston into the master

Install the push rod into the master cylinder.

Install the snap ring into the groove in the master

Make sure the snap

cylinder using the special tool.

ring is firmly seated

in the groove.

Snap ring pliers

Apply silicone grease to the boot groove in the push

rod and install the boot into the master cylinder and

boot groove.

If the push rod joint is reinstalled, adjust the push

rod length so the distance from the center of the

lower mounting bolt hole to the center of the joint

pin hole is 69 mm (2.7 in). After adjustment, tighten

the joint nut.

TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)

07914-SA50001

MA TER CYLINDER

Troubleshooting