Honda GL1800 Service Manual page 473

REAR WHEEL/SUSPENSION
Retighten the right pivot bolt to the same torque.
TORQUE: 108 N·m (11.0 kgf·m, 80 lbf·ft)
Install the left pivot lock nut.
Hold the left pivot bolt while tightening the left pivot
Refer to torque
lock nut to the specified torque.
wrench reading
information on
TOOL:
page 14-3 "Service
Lock nut wrench, 10 x 44/6 x 46 mm
Information. "
TORQUE: Actual: 108 N·m (11.0 kgf·m, 80 lbf·ft)
Insert the shock arm-to-shock link bolt from the left
side through the shock link, shock arm and shock
link.
Install the mounting nut and tighten the nut to the
specified torque.
TORQUE: 64 N·m (6.5 kgf·m, 47 lbf·ft)
Install the joint boot over the engine securely.
Apply locking agent to the threads of the switch
holder screws.
Install the brake light/cruise cancel switch assembly
with the screws.
Adjust the switch position so that the brake light
comes on when pushing the brake pedal slightly
and the push rod moves 0.7 – 1.7 mm.
Tighten the holder screws.
TORQUE: 2 N·m (0.2 kgf·m, 1.4 lbf·ft)
Install the brake pipe clamp with the bolt and
tighten the bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
14-28
07ZMA-MCAA101
Indicated: 98 N·m (10.0 kgf·m, 72 lbf·ft)
JOINT BOOT
CREW
OLT
UT A D BOLT
SHOCK ARM
WITCH
A EMBLY
PIPE CLAMP