Honda GL1800 Service Manual page 457

REAR WHEEL/SUSPENSION
Suspension level cannot be memorized with the
memory switch
1. Memory Switch 1 and 2 Operation Inspection
Remove the left fairing pocket (page 2-11).
Disconnect the panel switch 14P gray connector.
Check for continuity between the wire terminals
of the switch side connector in either MEMO 1 or
MEMO 2 switch positions. Continuity should
exist between the color coded wires as follows:
MEMO 1 SWIT H
Position
MEMO 2 SWIT H
Position
Is there continuity between the wires as shown
in the charts?
NO
YES
2. Memory Switch 1 and 2 Control Line Short
Circuit inspection
Remove the combination meter (page 20-17).
Check the following wires for continuity to
ground at the panel switch 14P gray connector.
– Brown/yellow
– Brown/blue
Is there continuity?
YES
NO
14-12
olor
Br/Y G/Y
PUSH
FREE
olor
Br/Bu G/Y
PUSH
FREE
– Faulty memory switch; replace the
panel switch assembly (page 20-32).
– GO TO STEP 2.
– Short circuit in the fairing sub-wire
harness.
– GO TO STEP 3.
G/Y
SWITCH SIDE CONNECTOR
(viewed from the terminal side)
IRE HARNESS SIDE 14P CONNECTOR
(viewed from the terminal side)
Br/Bu
Br/Y
r/ u
r/Y