Front Brake Caliper - Honda SH300 2006 Manual

INSTALLATION
Install the delay valve and tighten the delay valve
mounting bolts.
Connect the brake hose to the delay valve with the
oil bolt and new sealing washers.
Tighten the brake hose oil bolt to the specified
torque while setting the hose joint against the stop-
per on the delay valve.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Apply clean brake fluid to the brake pipe joint nut
thread.
Install the brake pipe to the delay valve and tighten
the joint nut to the specified torque.
TORQUE: 14 N·m (1.4 kgf·m, 10 lbf·ft)
Fill brake fluid and bleed air the hydraulic system
(page 17-7).
Install the following:
– front inner cover (page 3-10)
– rear handlebar cover (page 3-14)
– front handlebar cover (page 3-14)
– front upper cover (page 3-9)

FRONT BRAKE CALIPER

REMOVE
Drain the brake fluid from the hydraulic system
(page 17-7).
Remove the following:
– two wire clamp bolts
ABS type only.
– wire guide
– two bolts
ABS type only.
– wheel speed sensor
HYDRAULIC BRAKE
BOLTS
BRAKE PIPE
STOPPER
CLAMP BOLTS
WHEEL SPEED SENSOR
DELAY VALVE
JOINT NUT
SEALING
WASHERS
OIL BOLT
GUIDE
BOLTS
17-27