Honda GL1800 Service Manual page 472

REAR WHEEL/SUSPENSION
Install the joint boot onto the swingarm with one
joint boot tab facing up vertically as shown.
Remove the joint shaft from the final gear case
(page 12-10) and temporarily install it into the drive
shaft to ease installation of the drive shaft.
Set the swingarm into the frame and engage the
Route the wires,
splines of the drive and output shafts securely.
hoses and pipes
properly
(page 1-23).
OUTPUT SHAFT
RIVE SHAFT
IGHT PIVOT BOLT
Align the frame pivot bolt hole with the swingarm
securely.
Install and tighten the right pivot bolt to the speci-
fied torque.
TORQUE: 108 N·m (11.0 kgf·m, 80 lbf·ft)
EFT PIVOT BO T
Align the frame pivot bolt hole with the swingarm
securely.
Install and tighten the left pivot bolt to the specified
torque.
TORQUE: 34 N·m (3.5 kgf·m, 25 lbf·ft)
Move the swingarm up and down several times to
seat the pivot bearings.
14-27