Rear Master Cylinder/Brake Pedal Removal - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:

Table of Contents

REAR MASTER CYLINDER/BRAKE

Drain the brake fluid from the pedal brake hydraulic

system (page 15-6).

Remove the two screws and brake light/cruise

cancel switch assembly from the master cylinder.

Remove the snap ring and disconnect the reservoir

When removing the

hose joint from the master cylinder.

hose joint and oil

Remove the O-ring.

bolt, cover the ends

of the hoses to pre-

Disconnect the brake hose by removing the oil bolt

vent contamination.

and sealing washers.

Remove the pinch bolt and the brake pedal.

Remove the two bolts and right footpeg.

Unhook the spring end to remove the return spring

from the frame and pivot arm.

Remove the master cylinder mounting bolts.

Remove the pedal pivot arm off the frame while

pushing the water hose aside, then the master cylin-

der/pivot arm assembly out of the frame.

BRAKE SYSTEM (Standard)

Troubleshooting