Lifter Joint Piece, Lifter Bearing; Clutch Disc; Clutch Plate - Honda GL1800 Service Manual

CLUTCH
INSPECTION

LIFTER JOINT PIECE, LIFTER BEARING

Check the lifter joint piece for damage or abnormal
wear and the oil passages in the joint piece for
debris.
Turn the lifter joint piece in the lifter bearing with
your finger. The bearing should turn smoothly and
quietly.
Also, check that the bearing races fit tightly in the
lifter plate and joint piece.
Replace the bearing as follows if the bearing does
not turn smoothly, quietly, or if the races fits
loosely.
Remove the snap ring and lifter joint piece.
Remove the snap ring and drive the bearing out of
the lifter plate.
Drive a new bearing into the plate with its mark side
facing up.
TOOLS:
Driver
Attachment, 32 x 35 mm
Pilot, 17 mm
Install the snap ring into the lifter plate groove
securely.
Install the lifter joint piece into the bearing and
secure it with the snap ring.

CLUTCH DISC

Check the clutch discs for signs of scoring or
Replace the clutch
discoloration.
discs and plates as
Measure the clutch disc thickness.
a set.
SERVICE LIMIT: 3.5 mm (0.14 in)

CLUTCH PLATE

Check the plates for discoloration.
Replace the clutch
Check for plate warpage on a surface plate using a
discs and plates as
feeler gauge.
a set.
SERVICE LIMIT: 0.30 mm (0.012 in)
9-18
07749–0010000
07746–0010100
07746-0040400
EARING
SNAP RING
LIFTER JOINT PIECE
NAP RING
BEARING