Left Fork Leg Needle Bearing Replacement - Honda GL1800 Service Manual

FRONT WHEEL/SUSPENSION/STEERING
Install the spring seat and spacer.
Coat a new O-ring with fork fluid and install it into
Tighten the fork cap
the fork cap groove.
after installing the
Install the fork cap into the fork tube.
fork tube into the
fork bridges.
LEFT FORK LEG NEEDLE BEARING
REPLACEMENT
Remove the dust seals from the fork slider.
Press the needle bearings out of the fork slider
using the special tools and a hydraulic press.
TOOL:
Needle bearing remover
Assembly collar
Apply grease to the needle rollers of the new
bearings.
Carefully press the needle bearings in the fork slider
until the depth from the fork slider outer surfaces is
specified value, using the same tool and a hydraulic
press.
SPECIFIED DEPTH: 3.5 mm (1.4 in)
Apply grease to the new dust seal lips and install
the seal until it is fully seated.
13-32
07946-KA50000
07965-166030A
PACER
-RING
EARING DRIVER REMOVER
PECIFIED DEPTH
BEARING
PRING EAT