Fork Removal - Honda GL1800 Service Manual

Hide thumbs Also See for GL1800:

Table of Contents

FRONT WHEEL/SUSPENSION/STEERING

Check the clearance between the brake disc and cal-

iper bracket on each side after installation.

The clearance should be at least 0.7 mm (0.28 in).

If the feeler gauge cannot be inserted easily, loosen

the axle holder bolts and pull the fork outward or

push inward to adjust the clearance. Then tighten

the axle holder bolts to the specified torque.

After installing the wheel, apply the front and rear

brakes several times and recheck the caliper clear-

ances between each surface of the brake disc and

the brake caliper. Failure to provide clearance will

damage the brake disc and affect braking efficiency.

Check the front wheel speed sensor air gap

ABS model only.

(page 16-29).

Install front fender A (page 2-6).

Install the front fender side covers (page 2-6).

Remove the front wheel (page 13-16).

Remove the following:

– front fender top cover

– two front fender B mounting bolts from the left

Troubleshooting