Actuator Cable Adjustment - Honda GL1800 Service Manual

REPLACEMENT
Remove the air cleaner housing (page 5-57).
Remove the cruise actuator cable from the cable
stay, and disconnect it from the actuator drum.
Remove the three tapping screws and the cruise
actuator unit from the control unit holder.
Install a new cruise actuator unit onto the control
unit holder and tighten the three tapping screws.
Connect the cruise actuator cable to the actuator
drum and install it onto the cable stay.
Adjust the cable position with the nuts so that the
distance between the cable cap screw end and stay
is 34 mm (1.34 in) as shown.
Install the air cleaner housing (page 5-57).

ACTUATOR CABLE ADJUSTMENT

Remove the top shelter (page 2-11).
Check that the projection of the actuator drum
aligns with the groove of the throttle drum by look-
ing through the hole as shown with a light.
CRUISE CONTROL SYSTEM
CTU TOR C BLE
CTU TOR DRUM
CRUISE AC UA OR UNI
CTU TOR C BLES
CTU TOR DRUM
HOLE
CTU TOR DRUM
THROTTLE DRUM
APPING SCREWS
34 mm
(1.34 in)
21-17