Reverse Position Switch Line; Starter Relay Switch Line; Control Module Line; Reverse Resistor Assembly Removal/Installation - Honda GL1800 Service Manual

STARTER/REVERSE SYSTEM

REVERSE POSITION SWITCH LINE

Connect the reverse regulator 20P connector.
Shift the transmission into neutral and turn the igni-
tion switch to "ON."
Push the reverse shift switch to "ON" and check
that the reverse indicator comes on.
Turn the ignition switch to "OFF" and disconnect
the reverse regulator 20P connector.
Turn the ignition switch to "ON."
Measure the voltage between the White/blue wire
terminal (+) of the wire harness side 20P connector
and ground (–).
There should be battery voltage.
After inspection, turn the reverse shift actuator to
the neutral position.

STARTER RELAY SWITCH LINE

Turn the ignition switch to "OFF."
Disconnect the 2P red connector of starter relay
switch A.
Check for continuity between the Brown/red wire
terminals of the reverse regulator and starter relay
switch A connectors.
There should be continuity.

CONTROL MODULE LINE

Remove the top shelter (page 2-11)
Turn the ignition switch to "OFF."
Disconnect cruise/reverse control module 26P gray
connector.
Check for continuity between the Light blue wire ter-
minals of the reverse regulator and control module
connectors.
There should be continuity.
REVERSE RESISTOR ASSEMBLY
REMOVAL/INSTALLATION
Remove the battery case (page 5-56).
Disconnect the reverse resistor 3P connector.
Remove the nut and cable from the reverse resistor
terminal.
Remove the two bolts and reverse resistor
assembly.
19-30
REVERSE REGULATOR CONNECTOR
(viewed from the terminal side)
hite/blue Light blue
Brown/red