CYLINDER HEAD/VALVE
CYLINDER HEAD COVER
INSTALLATION
Clean the gasket mating surfaces of the cylinder
head and cover thoroughly, being careful not to
damage them.
Install a new gasket into the groove in the cylinder
head cover.
Install the special washers onto the head cover
bolts with the "UP" mark facing the bolt head.
Apply sealant to the semi-circular edges of the cyl-
inder head as shown.
Install the head cover by aligning the semi-circular
Be careful not to
areas of the cylinder head and gasket properly,
damage the semi-
then install the cover bolts (left side: six bolts, right
circular area of the
side: five bolts) by aligning them with the bolt holes
gasket.
in the cylinder head.
Tighten the head cover bolts in a crisscross pattern
in several steps.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the three rubber plugs.
Install the wire clip and the clamp with the bolt.
Route the plug
wires properly
(page 1-23).
8-32
ASKET
LIP
LAMP
BOLTS
BOLTS AND
PLUGS