Honda GL1800 Service Manual page 432

Install the fork tube into the fork slider.
Hold the fork slider in a vise with soft jaws or a shop
If the fork damper
towel.
turns with the cen-
Apply locking agent to the center bolt threads.
ter bolt, tempo-
Install the center bolt with a new sealing washer
rarily install the fork
and tighten it to the specified torque.
spring, spring seat,
spacer and fork
TORQUE: 20 N·m (2.0 kgf·m, 14 lbf·ft)
cap.
Drive the oil seal into the fork slider until the stopper
ring groove is visible using the special tool.
TOOL:
Fork seal driver, 45 mm
Install the stopper ring into the groove in the fork
slider being careful not to scratch the fork tube slid-
ing surface.
Apply fork fluid to the lip of a new dust seal and
install the dust seal.
FRONT WHEEL/SUSPENSION/STEERING
07KMD-KZ30100
07KMD-KZ3010A
(U.S.A. only)
ORK DAMPER
OIL LOCK PIECE
ORK SEAL DRIVER
STOPPER RING
UST SEAL
13-37