Pressure Regulator Replacement - Honda GL1800 Service Manual

PRESSURE REGULATOR
REPLACEMENT
Remove the radiator stay (page 5-61).
Hold the pressure regulator and loosen the nut.
Remove the pressure regulator and joint pipe from
the pressure regulator stay.
Disconnect the vacuum hose and fuel return hose
from the pressure regulator.
Remove the O-rings from the joint pipe.
Coat the new O-rings with oil and install them onto
the joint pipe.
Install the joint pipe into the pressure regulator stay.
Connect the fuel return hose and vacuum hose onto
the pressure regulator.
Install the pressure regulator onto the stay and
tighten the nut by hand.
Align the index lugs on the pressure regulator and
stay, and tighten the nut while holding the
regulator.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Install the removed parts in the reverse order of
removal.
FUEL SYSTEM (Programmed Fuel Injection)
UT
ACUUM HOSE
O-RINGS
UT
PRESSURE REGULATOR
FUEL RETURN HOSE
OINT PIPE
PRESSURE REGULATOR
5-65