Transmission Assembly - Honda GL1800 Service Manual

Stake the lock nut into the mainshaft groove.
Be careful not to
damage the
mainshaft threads.

TRANSMISSION ASSEMBLY

• Align the lock washer tabs with the splined
washer grooves.
• Always install the thrust washer and snap ring
with the chamfered (rolled) edge facing away
from the thrust load (see the illustration on
page 10-34).
• Install the snap ring so its end gap aligns with
the groove in the splines (page 10-33).
• Make sure the snap ring is fully seated in the
shaft groove after installing it.
GEARSHIFT LINKAGE/TRANSMISSION
OCK WASHER
Gap aligned
with spline
Incorrect
NAP RING
take
Gap aligned
with groove
Correct
10-33