Secondary Master Cylinder Disassembly - Honda GL1800 Service Manual

BRAKE SYSTEM (Standard)
Install the footpeg and tighten the bolts.
TORQUE: 26 N·m (2.7 kgf·m, 20 lbf·ft)
Apply locking agent to the threads of the switch
holder screws.
Install the brake light/cruise cancel switch assembly
with the screws.
Adjust the switch position so that the brake light
comes on when pushing the brake pedal slightly
and the push rod moves 0.7 – 1.7 mm.
Tighten the switch holder screws.
TORQUE: 2 N·m (0.2 kgf·m, 1.4 lbf·ft)
Fill and bleed the pedal brake hydraulic system
(page 15-7).
SECONDARY MASTER CYLINDER
DISASSEMBLY
Drain the brake fluid from the pedal brake hydraulic
system (page 15-6).
Remove the following:
When removing the
– front fender B (page 13-16)
oil bolt, cover the
– oil bolt and sealing washers
ends of the hoses
– upper side brake hose
to prevent
contamination.
– caliper-to-master cylinder joint bolt
– mounting bolts
15-24
OOTPEG
IL B LT