Ring Gear Installation - Honda GL1800 Service Manual

Install the washers.
Place the washers
Install the special tools.
under the holder
Tighten the pinion joint nut.
plate (on the top
and bottom stud
TOOLS:
bolts, on the oil
Pinon holder
drain bolt side) to
Collar set "C"
compensate for the
Holder plate
angle of the pinion
shaft.
TORQUE: 108 N·m (11.0 kgf·m, 80 lbf·ft)

RING GEAR INSTALLATION

Check that the ring gear stud bolts are tight.
If any are loose, remove them, clean their threads
with contact cleaner, then install using locking
agent.
After installing, be sure to measure the distance
from the top of each stud to the ring gear surface as
shown.
Install the right side shim onto the ring gear.
Support the bearing inner race with the special tool
and press the ring gear into the case cover.
TOOL:
Assembly base
07924-ME40010
07924-ME40020
07924-9690103 or
07924-9690101
(modified)
07ZMF-MCAA300
FINAL DRIVE
ING GEA
IGHT SHIM
)5-
40.5±1 mm
12-19