Quarter Window - Chrysler 2005 Crossfire SRT6 Service Manual

23 - 448 STATIONARY GLASS

QUARTER WINDOW

REMOVAL
WARNING: WEAR EYE AND HAND PROTECTION
WHEN HANDLING GLASS. PERSONAL INJURY
CAN RESULT.
1. Cut urethane bonding from around quarter window
glass (1) using a suitable sharp cold knife (2). A
pneumatic cutting device can be used if available.
CAUTION: Do not damage body or trim finish
when cutting out glass or applying fence primer.
2. Drill and remove quarter glass retaining rivets (3).
3. Separate glass (1) from vehicle.
INSTALLATION
CAUTION: Open a window before installing glass. This will avoid pressurizing the passenger compartment.
If a door or liftgate is slammed before urethane is cured, water leaks can result.
Note: The quarter window fence should be cleaned of old urethane bonding material. Support spacers
should be cleaned and properly installed on weld studs or repair screws at bottom of quarter window
opening.
The window opening fence should be cleaned of old
urethane bonding material (1).
Refer to the Windshield Removal procedure for a
description of tools, cleaning procedures, and adhe-
sive systems that are recommended for use in this
procedure.(Refer to 23 - BODY/STATIONARY GLASS/
WINDSHIELD - REMOVAL).
1. Clean inside of glass (2) with Mopar Glass Cleaner
and lint-free cloth.
2. Apply clear glass primer 25 mm (1 in.) wide around
edge of glass (2). Wipe with clean/dry lint-free
cloth.
Note: Insure primer does not flow passed the
black frit.
3. Apply black primer 25 mm (1 in.) wide around edge
of glass (2). Allow at least eighteen minutes drying
time.
4. Apply a 12 mm (0.5 in.) high by 8 mm (0.3 in.) wide triangular bead of urethane (3) around window edge.
5. Position glass (2) into window opening and rivet into place using 2 rivets (4).
ZH