Chrysler 2005 Crossfire SRT6 Service Manual page 3666

23 - 118 CONVERTIBLE TOP
9811 HYDRAULIC SOLENOID S1 SUPPLY VOLTAGE CIRCUIT OPEN/SHORT TO B(+) (CONTINUED)
3.
Hydraulic Solenoid S1
With the ignition off.
Measure the resistance between the Hydraulic Solenoid S1 Supply
Voltage circuit and the Hydraulic Solenoid S1/S2 Ground circuit from
the Power Top Control Module C2 harness connector.
Is the resistance between 6.0 - 15.0 ohms?
Yes >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 4
4.
Open Hydraulic Solenoid S1 Supply Voltage circuit
With the ignition off.
Disconnect the Hydraulic Solenoid S1 harness connector.
Measure the resistance of the Hydraulic Solenoid S1 Supply Voltage
circuit from the Power Top Control Module C2 harness connector to
the Hydraulic Solenoid S1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Hydraulic Solenoid S1 Supply Voltage circuit for
an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
ZH