Chrysler 2005 Crossfire SRT6 Service Manual page 3719

ZH
9909 REAR BOW SWITCH SENSE CIRCUIT OPEN (CONTINUED)
3.
Open Rear Bow Switch Sense circuit
Turn the ignition off.
Remove fused jumper wire.
Disconnect the Power Top Control Module C1 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Rear Bow Switch Sense circuit from the
Rear Bow Switch harness connector to the Power Top Control Module
C1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 4
No >> Repair the Rear Bow Switch Sense circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
4.
Open Rear Bow Switch Ground circuit
With the ignition off.
Measure the resistance between ground and the Rear Bow Switch
ground circuit.
Is the resistance below 5.0 ohms?
Yes >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Repair the Rear Bow Switch Ground circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
CONVERTIBLE TOP 23 - 171