Chrysler 2005 Crossfire SRT6 Service Manual page 4305

25 - 12 EMISSIONS CONTROL
ZH
the PCM). Because the condition happens at an engine speed above the maximum threshold (2000 rpm), the PCM
will not store a DTC.
There are several operating conditions for which the PCM monitors and sets DTCs. Refer to Monitored Systems,
Monitored Components, and Non-Monitored Circuits in this section.
Note: Various diagnostic procedures may actually cause a diagnostic monitor to set a DTC. For instance,
pulling a spark plug wire to perform a spark test may set the misfire code. When a repair is completed and
verified, use the DRB III scan tool to erase all DTCs and extinguish the MIL.
Technicians can retrieve stored DTCs. For obtaining
the DTC information, use the Data Link Connector (2)
with the DRB III scan tool.