Chrysler 2005 Crossfire SRT6 Service Manual page 3623

ZH
9630 REAR BOW TRAVEL SENSOR (ROD SIDE) +/- CIRCUIT OPEN/SHORT TO GROUND (CONTINUED)
4.
Open Rear Bow Travel Sensor (Rod Side) (-) Circuit
Turn the ignition off.
Disconnect the Power Top Control Module C1 harness connector.
Measure the resistance of the Rear Bow Travel Sensor (Rod Side) (-)
circuit from the Power Top Travel Sensor harness connector to the
Power Top Control Module C1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the open Rear Bow Travel Sensor (Rod Side) (-)
circuit.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
5.
Rear Bow Travel Sensor (Rod Side) (-) Circuit Shorted to Ground
With the ignition off.
Measure the resistance between ground and the Rear Bow Travel
Sensor (Rod Side) (-) circuit.
Is resistance below 100 kohms?
Yes >> Repair the Rear Bow Travel Sensor (Rod Side) (-) circuit
for a short to ground.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
CONVERTIBLE TOP 23 - 75