Chrysler 2005 Crossfire SRT6 Service Manual page 4071

23 - 510 CONVERTIBLE TOP
6. Carefully pry the metal snap ring (1) from the end
of the hydraulic line (2).
7. Slide the hydraulic line out of the retaining plate.
8. Remove the hydraulic line from the vehicle.
INSTALLATION
Note: The hydraulic lines must be replaced in
pairs.
Note: Always replace all O-rings and metal snap
rings when servicing the hydraulic lines.
1. Starting from the pump side of the hydraulic line
(straight coupler), insert the new hydraulic line
through the proper hole location on the line reten-
tion plate.
Note: The hydraulic line must be inserted into the
proper cavity of the pump.
2. Slide the cone mechanism of Special Tool 9108 (2)
onto the coupling end of the hydraulic line (1).
ZH