Table of Contents
Advertisement
ZH
6. After urethane has cured, water test quarter window to verify repair.
WINDSHIELD
REMOVAL
1. Remove inside rear view mirror.(Refer to 8 - ELEC-
TRICAL/POWER MIRRORS/AUTOMATIC DAY /
NIGHT MIRROR - REMOVAL).
2. Remove cowl cover.(Refer to 23 - BODY/EXTERI-
OR/COWL GRILLE - REMOVAL).
3. Remove upper windshield molding (2).
4. Remove windshield side moldings (1).
WARNING: WEAR EYE AND HAND PROTECTION
WHEN HANDLING GLASS. PERSONAL INJURY
CAN RESULT.
CAUTION: Do not damage body or trim finish
when cutting out glass or applying fence primer.
5. Cut urethane bonding from around windshield (2)
using a suitable sharp cold knife (1). A pneumatic
cutting device can be used if available.
6. Separate windshield (2) from vehicle.
INSTALLATION
WARNING: DO NOT OPERATE THE VEHICLE WITHIN 24 HOURS OF WINDSHIELD INSTALLATION. IT TAKES
AT LEAST 24 HOURS FOR URETHANE ADHESIVE TO CURE. IF IT IS NOT CURED, THE WINDSHIELD MAY
NOT PERFORM PROPERLY IN AN ACCIDENT. BE SURE TO REFER TO THE URETHANE MANUFACTURER'S
DIRECTIONS FOR CURING TIME SPECIFICATIONS, AND DO NOT USE ADHESIVE AFTER ITS EXPIRATION
DATE.
STATIONARY GLASS 23 - 449
Advertisement
Chapters
Table of Contents
