Chrysler 2005 Crossfire SRT6 Service Manual page 4180

ZH
A/C COMPRESSOR CLUTCH CIRCUIT (CONTINUED)
2.
MEASURE THE RESISTANCE OF THE A/C COMPRESSOR CLUTCH SIGNAL CIRCUIT
With the ignition off.
Disconnect the A/C Heater Control Module harness connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance of the A/C Compressor Clutch signal circuit
from the inline connector C106 to the A/C Heater Control Module har-
ness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the A/C Heater Control Module. (Refer to 24 -
HEATING & AIR CONDITIONING/CONTROLS/HEATER
CONTROL - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the A/C Compressor Clutch signal circuit for an
open.
Perform BODY VERIFICATION TEST.
3.
MEASURE THE RESISTANCE OF THE A/C COMPRESSOR CLUTCH SIGNAL CIRCUIT
With the ignition off.
Disconnect the A/C Compressor Clutch connector.
Note: Check connector - Clean/repair as necessary.
Measure the resistance of the A/C Compressor Clutch signal circuit
from the inline connector C106 to the A/C Compressor Clutch connec-
tor.
Is the resistance below 5.0 ohms?
Yes >> Replace the A/C Compressor Clutch. (Refer to 24 - HEAT-
ING & AIR CONDITIONING/PLUMBING/A/C COMPRES-
SOR - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the A/C Compressor Clutch signal circuit for an
open.
Perform BODY VERIFICATION TEST.
HEATING & AIR CONDITIONING - ELECTRICAL DIAGNOSTICS 24 - 51