Chrysler 2005 Crossfire SRT6 Service Manual page 3551

ZH
BODY CONTROL MODULE INTERNAL FAILURE (CONTINUED)
When Monitored and Set Condition
• When Monitored: Continuous.
• Set Condition: If the Body Control Module (BCM) detects an internal malfunction, the DTC is set.
OPEN FUSED B(+) CIRCUIT
BODY CONTROL MODULE
For a complete Rear Spoiler Circuit Diagram. (Refer to 23 - BODY - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
FUSED B(+) CIRCUIT
Turn the ignition off.
Disconnect the BCM C4 harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the voltage of the Fused B(+) circuit at the BCM C4 harness
connector.
Is the voltage above 10.0 volts?
Yes >> Replace the Body Control Module.(Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform REAR SPOILER VERIFICATION TEST.
No >> Repair the Fused B(+) circuit for an open.
Perform REAR SPOILER VERIFICATION TEST.
BODY - ELECTRICAL DIAGNOSTICS 23 - 3
POSSIBLE CAUSES