Chrysler 2005 Crossfire SRT6 Service Manual page 4005

23 - 444 SEATS
INSTALLATION
1. Insert the longitudinal upholstery wires into the fab-
ric sleeves in the cover (3).
2. Fold the cover over and position it on the foam rub-
ber pad (1).
3. Hook the middle longitudinal upholstery wire onto
the wire, insert it in the foam rubber pad (1) with
the fabric straps (2).
4. Pull the rear lateral upholstery wire into the fabric
sleeve in the cover (3).
5. Install the side longitudinal retainers and the rear
lateral retainers.
6. Pull the cover (3) to the side over the foam rubber
pad (1).
Note: Insert one additional retaining clip in clip
groove at front center (arrow)
7. Position the seat cushion shell (1), align the cover
(2) and hook the cover into the cushion shell (1) all
the way around.
8. Hook fabric tabs on the left and right into the cush-
ion shell. Trim the seam on cover in this area.
ZH