Chrysler 2005 Crossfire SRT6 Service Manual page 3660

23 - 112 CONVERTIBLE TOP
9721 LEFT ROTATION RELAY CONTROL CIRCUIT OPEN/SHORT TO B(+) (CONTINUED)
3.
PTCM
Turn the ignition off.
Measure the resistance between the Rotation Relay Ground circuit
and the Left Rotation Relay Control circuit at the Power Top Control
Module C2 harness connector.
Is the resistance between 60.0 - 90.0 ohms?
Yes >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 4
4.
Left Rotation Relay Control Circuit
With the ignition off.
Disconnect the Left Rotation Relay harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Left Rotation Relay Control circuit from
the Left Rotation Relay harness connector and the PTCM C2 harness
connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Left Rotation Relay Control circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
ZH