Chrysler 2005 Crossfire SRT6 Service Manual page 4093

23 - 532 CONVERTIBLE TOP
REMOVAL - LATCH RETAINER
Note: Right side shown, left side similar.
1. Lower the convertible top.
2. Remove both A-pillar trim panels. (Refer to 23 -
BODY/INTERIOR/A-PILLAR TRIM - REMOVAL).
3. Remove both sun visors.
4. Remove the dome lamp assembly.
5. Remove the lower windshield trim panel and dis-
connect the universal transmitter harness connec-
tor.
6. Remove the upper windshield trim panel.
7. Disconnect the latch retainer switch harness con-
nector (5).
8. Remove the latch retainer bolts (4) and remove the
shim (3) and retainer (2) from the windshield
header (1).
INSTALLATION
INSTALLATION - REAR BOW LATCH
1. Install the rear bow latch to the tonneau cover.
Tighten screws (2) to 8 N·m (71 in. lbs.).
2. Connect the hydraulic lines (1) to the rear bow
latch.
3. Connect the rear bow latch harness connector (3).
4. Connect the negative battery cable.
ZH