Chrysler 2005 Crossfire SRT6 Service Manual page 3633

ZH
9640 REAR BOW TRAVEL SENSOR (BASE SIDE) +/- CIRCUIT OPEN/SHORT TO GROUND (CONTINUED)
3.
Rear Bow Travel Sensor (Base Side) (+) circuit
Remove the jumper wire.
With the ignition on.
Measure the voltage of the Rear Bow Travel Sensor (Base Side) (+)
circuit at the Power Top Travel Sensor harness connector.
Is the voltage above 10.0 volts?
Yes >> Go To 4
No >> Go To 6
4.
Open Rear Bow Travel Sensor (Base Side) (-) Circuit
Turn the ignition off.
Disconnect the Power Top Control Module C1 harness connector.
Measure the resistance of the Rear Bow Travel Sensor (Base Side) (-)
circuit from the Power Top Travel Sensor harness connector to the
Power Top Control Module C1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Rear Bow Travel Sensor (Base Side) (-) circuit
for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONVERTIBLE TOP 23 - 85