Chrysler 2005 Crossfire SRT6 Service Manual page 3691

ZH
9861 TRUNK LATCH ACTUATOR UNLOCK CONTROL CIRCUIT SHORT TO B(+) (CONTINUED)
• When Monitored: Continuously with the ignition on.
• Set Condition: When the Power Top Control Module (PTCM) senses B(+) on the Trunk Latch Actuator
Unlock Control circuit.
TRUNK LATCH ACTUATOR UNLOCK CONTOL CIRCUIT SHORT TO B(+)
OPEN TRUNK LATCH ACTUATOR LOCK CONTROL CIRCUIT
OPEN TRUNK LATCH ACTUATOR UNLOCK CONTROL CIRCUIT
TRUNK LATCH ASSEMBLY
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Trunk Latch Assembly
Turn the ignition off.
Disconnect the Trunk Latch Assembly C2 harness connector.
Note: Check connectors — Clean/repair as necessary.
Using a 12-volt test light connected to between the Trunk Latch Actua-
tor Lock Control circuit and the Trunk Latch Actuator Unlock Control
circuit at the Trunk Latch Assembly C2 harness connector.
Turn the ignition on.
With DRBIII , select Actuator Test and actuate the TRUNK LATCH
ACT UNLOCK.
Does the test light illuminate brightly when actuated?
Yes >> Replace the Trunk Latch Assembly.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 2
Possible Causes
CONVERTIBLE TOP 23 - 143