Chrysler 2005 Crossfire SRT6 Service Manual page 4012

ZH
6. Clean inside of windshield (1) with Mopar Glass Cleaner and lint-free cloth.
7. Apply clear glass primer (2) 25 mm (1 in.) wide (5)
around edge of windshield (1). Wipe with clean/dry
lint-free cloth (3).
8. Apply black-out primer (4) 25 mm (1 in.) wide (5)
on top and sides of windshield (1) and 25 mm (1
in.) (5) on bottom of windshield (1). Allow at least
three minutes drying time.
Note: Make sure the clear and black primers do
not flow passed the black frit.
9. Apply a 12 mm (0.47 in.) high by 8 mm (0.31 in.)
wide triangular bead of urethane (6) around perim-
eter of windshield along the inside of the moldings.
Apply two beads along the bottom edge.
10. Apply fence primer around the perimeter of the
windshield opening fence (1). Allow at least 18
minutes drying time.
11. With aid of a helper, position windshield (3) over
windshield opening. Align reference marks at bot-
tom of windshield to support spacers (2).
12. Slowly lower windshield glass to windshield open-
ing fence (1). Guide velcro-stabilizers at the lower
edge of the replacement windshield into proper
position as necessary. Push windshield inward to
fence spacers (2) at top and bottom until top is
flush to roof line.
13. Clean excess urethane from exterior with Mopar
Super Clean or equivalent.
STATIONARY GLASS 23 - 451