Chrysler 2005 Crossfire SRT6 Service Manual page 4239

24 - 110 DISTRIBUTION
7. Remove the steering wheel and steering column.
(Refer to 19 - STEERING/COLUMN - REMOVAL).
8. Remove the instrument cluster bezel (1) by remov-
ing the five screws then pulling out at the bottom
and down at the top.(Refer to 23 - BODY/INSTRU-
MENT PANEL/INSTRUMENT PANEL ASSEMBLY -
REMOVAL).
9. Remove the front and rear center consoles. (Refer
to 23 - BODY/INTERIOR/CENTER CONSOLE -
REMOVAL).
10. Remove the I/P top cover. (Refer to 23 - BODY/
INSTRUMENT PANEL/INSTRUMENT
ASSEMBLY - REMOVAL).
11. Remove the instrument cluster and bracket
assembly. (Refer to 23 - BODY/INSTRUMENT
PANEL/INSTRUMENT
REMOVAL).
12. Disconnect the SKREEM harness connectors and
remove SKREEM module and mounting bracket.
(Refer to 8 - ELECTRICAL/VEHICLE THEFT SECURITY/SENTRY KEY REMOTE ENTRY MODULE -
REMOVAL).
13. Remove the glove box assembly. (Refer to 23 - BODY/INSTRUMENT PANEL/GLOVE BOX - REMOVAL).
14. Disconnect the passenger side air bag harness
connector (1).
15. Disconnect the vacuum reservoir solenoid con-
nector and vacuum hose (2) then remove the vac-
uum reservoir.
16. Disconnect the recirculated air switchover valve
connector (3).
PANEL
PANEL ASSEMBLY -
ZH