Chrysler 2005 Crossfire SRT6 Service Manual page 4076

ZH
REMOVAL
REMOVAL - HYDRAULIC PUMP MOTOR
1. Disconnect the negative battery cable.
2. Remove the left trunk trim panel.
3. Remove the power top control module (Refer to 8 -
ELECTRICAL/ELECTRONIC
ULES/POWER TOP
REMOVAL).
4. Disconnect the tonneau cover hydraulic cylinder at
the tonneau cover hinge (1).
5. Disconnect the power top hydraulic assembly har-
ness connector (2).
6. Remove the power top hydraulic assembly retain-
ing nuts (3) and lift the pump assembly out of the
trunk well.
7. Remove the three bolts (1) from the hydraulic line
retaining plate.
8. Separate the hydraulic line retaining plate from the
power top hydraulic assembly.
9. Remove the power top hydraulic assembly from the
vehicle.
CONTROL MOD-
CONTROL MODULE -
CONVERTIBLE TOP 23 - 515