Chrysler 2005 Crossfire SRT6 Service Manual page 4216

ZH
INSTALLATION
1. Clip the ambient air temperature to the front
bumper support.
2. Connect the ambient air temperature harness con-
nector (2).
3. Close the installation flap for left fog lamp located
in the left inner fenderwell.
4. Install the engine compartment lower panel.
5. Connect the negative battery cable.
EVAPORATOR TEMPERATURE SENSOR
REMOVAL
1. Remove the center console. (Refer to 23 - BODY/
INTERIOR/CENTER CONSOLE - REMOVAL).
2. Remove the evaporator temperature sensor located
on the left side of the heater A/C case.
3. Disconnect the evaporator temperature sensor har-
ness connector from the sensor.
CONTROLS 24 - 87