ZH
9. Remove the lower instrument panel (2).(Refer to 23
-
BODY/INSTRUMENT
PANEL ASSEMBLY - REMOVAL).
10. Remove the instrument cluster cover (1).(Refer to
23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL ASSEMBLY - REMOVAL).
11. Remove the green insulating mats.
12. Remove the nuts for the instrument cluster holder
then remove instrument cluster.(Refer to 8 -
ELECTRICAL/INSTRUMENT
REMOVAL).
13. Remove the Sentry Key Remote Entry Module
(SKREEM) by:
• Disconnect the 2-pin CAN harness connector
from the SKREEM (1).
• Disconnect the 2-pin harness connector for the
transponder coil (1).
• Disconnect the 18-pin harness connector (1).
• Press the retaining tabs apart (1).
• Remove the SKREEM control module from the
base plate.
Note: This is necessary to remove the instrument
panel support from the vehicle.
14. Remove all of the wiring harness nylon ties
attaching the wiring harnesses on the instrument
panel support.
PANEL/INSTRUMENT
CLUSTER
-
DISTRIBUTION 24 - 103