Chrysler 2005 Crossfire SRT6 Service Manual page 3655

ZH
9711 RIGHT ROTATION RELAY CONTROL CIRCUIT OPEN/SHORT TO B(+) (CONTINUED)
5.
Open Rotation Relay Ground circuit
With the ignition off.
Measure the resistance of the Rotation Relay Ground circuit from the
Right Rotation Relay harness connector to the PTCM C2 harness con-
nector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Right Rotation Relay.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Repair the Rotation Relay Ground circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
6.
Rotation Relay Ground Circuit
Turn the ignition off.
Disconnect the Power Top Control Module C2 harness connector.
Measure the resistance between the Rotation Relay Ground circuit and the Right Rotation Relay Control circuit at
the Power Top Control Module C2 harness connector.
Is the resistance between 60.0 - 90.0 ohms?
Yes >> Replace the Power Top Control Module.(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MOD-
ULES/POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICATION TEST.
No >> Repair the Rotation Relay Ground circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICATION TEST.
CONVERTIBLE TOP 23 - 107