Chrysler 2005 Crossfire SRT6 Service Manual page 4062

ZH
INSTALLATION
INSTALLATION - TONNEAU COVER CYLINDER
1. Install tonneau cover cylinder (1) to pump bracket
(2) and install the lower retainer (3).
Note: Be sure to use new retainers and O-rings
when installing hydraulic lines to the cylinder.
2. Connect hydraulic lines to cylinder with new retain-
ers.
3. Connect both travel sensors to the cylinder.
4. Install the hydraulic pump assembly (Refer to 23 -
BODY/CONVERTIBLE TOP/HYDRAULIC
MOTOR - INSTALLATION).
5. Install the left side trunk trim panel.
6. Connect the negative battery cable.
INSTALLATION - MAIN CYLINDER
1. Install the travel sensors on the cylinder (left side
only).
2. Connect the hydraulic lines to the cylinder with a
new O-rings and retainers.
3. Position the main cylinder (1) into the top frame
assembly and install the retainers (2).
4. Lower the tonneau cover manually and relatch the
rear bow (Refer to 23 - BODY/CONVERTIBLE TOP
- STANDARD PROCEDURE).
5. Connect the negative battery cable.
PUMP
CONVERTIBLE TOP 23 - 501