Chrysler 2005 Crossfire SRT6 Service Manual page 3952

ZH
4. Expose the lines in the area of the center console
and attach the two halves of the floor covering at
the front and rear with clips (1) along the cutting
line. For this purpose cut slits in both of the carpet
halves with a blade and then insert the clips (1).
5. Install the plugs and the edge protector at the rear
in the lower area.
6. Connect the electrical connector to the parking
brake switch.
7. Install the storage pocket.
8. Install the paneling (2) in the left footwell.
9. Install the door sill trim plate (4). (Refer to 23 -
BODY/INTERIOR/DOOR SILL TRIM PLATE -
INSTALLATION). Install the edge guard (1) in the
area of the paneling (2). Install the screw (3) then
install the cap.
10. Install the cover below instrument panel. (Refer to
23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL ASSEMBLY - INSTALLATION).
11. Install the air outlet cover in the footwell.
12. Install the ashtray housing with the stowage com-
partment in the front center console. (Refer to 23
- BODY/INTERIOR/CENTER
INSTALLATION).
13. Install the cover on the center console. (Refer to
23 - BODY/INTERIOR/CENTER CONSOLE -
INSTALLATION).
14. Install the rear center console. (Refer to 23 -
BODY/INTERIOR/CENTER CONSOLE - INSTAL-
LATION).
15. Install the front seat. (Refer to 23 - BODY/SEATS/SEAT - INSTALLATION).
CONSOLE -
INTERIOR 23 - 391