Table of Contents
Advertisement
ZH
6. Install the gas prop rod (2) to the hood at the top
then install the gas prop rod retainer (1).
7. Shut the hood and insure that the hood shuts prop-
erly and securely and that there is a uniform gap
around the hood to the front fenders and grille.
8. Verify fit of hood to vehicle body. Adjust as neces-
sary.
(Refer
to
23
ADJUSTMENTS).
ADJUSTMENTS
ADJUSTMENT - HOOD
ADJUSTING IN LONGITUDINAL AND VERTICAL DIRECTIONS
Note: For minor adjustment in longitudinal and
vertical directions; for larger adjustment path see
steps 4 - 10.
1. Open the hood.
2. Loosen the bolts (1,2) on the hood hinges and
adjust the hood.
3. Tighten the bolts. Tighten to 10 N·m (88 in. lbs.).
4. Move the hood to its fully upright position. (Refer to
23 - BODY/HOOD/HOOD - STANDARD PROCE-
DURE.)
5. Remove the gas prop rod from the hood at the top
and lay it down in the engine compartment.
6. Close the hood.
7. Remove the inner fender from the front fender.
8. Loosen the bolts on the hood hinges in the front
fender.
Note: For larger adjustment path loosen the top section of the hood latch, adjust and retighten.
9. Adjust the hood so that the front edge of the front fender coincides with the hood and the top edges are flush.
-
BODY/HOOD/HOOD
-
HOOD 23 - 333
Advertisement
Chapters
Table of Contents
