Chrysler 2005 Crossfire SRT6 Service Manual page 4318

ZH
TUBE
REMOVAL
1. Remove the air cleaner housing.
2. Remove the EGR tube mounting bolts (1) at the
intake manifold.
3. Remove the EGR tube flange nut (2) at the EGR
valve.
4. Remove the EGR tube.
5. Clean the gasket surfaces on the EGR tube and
intake manifold. Discard old gasket.
Note: Any loose dirt can lodge between the tube
and manifold and cause vacuum leakage that will
give a rough idle and reduced manifold vacuum.
INSTALLATION
1. Loosely install the EGR tube flange nut (2) to the
EGR valve.
2. Position the new gasket between tube and intake
manifold.
3. Install the tube bolts (1) to intake manifold. Tighten
to 31 N·m (23 ft. lbs.).
4. Tighten the EGR tube flange nut (2) to 11 N·m (95
in. lbs.).
5. Install the air cleaner housing.
EXHAUST GAS RECIRCULATION 25 - 25