Chrysler 2005 Crossfire SRT6 Service Manual page 4310

ZH
3. Blow compressed air through each tube (1 and 3) and the draft-tube style insert (2). Check for blockage or
restrictions. If cleaning is necessary, spray a soapy-type all-purpose cleaner into each component and blow out.
After restriction is cleared, rinse out component with clear water. Blow water from component and install to vehi-
cle. To prevent damage to plastic components, never spray carburetor-type cleaner into any of the plastic
tubes.
EVAP PURGE SOLENOID
DESCRIPTION
This vehicle uses a pulse-width modulated EVAP Purge Solenoid. The solenoid regulates the rate of vapor flow from
the EVAP canister to the throttle body. The PCM controls the frequency at which the solenoid operates in order to
customize the vapor volume for each cylinder.
OPERATION
The PCM will only energize the EVAP solenoid when the engine is at operating temperature, but will de-energize it
during periods of deceleration. When de-energized, no vapors are purged.
The pulse-width modulated EVAP Purge Solenoid controls the fuel vapor purge rate from the Vapor Canister and
fuel tank to the engine intake manifold.
REMOVAL
REMOVAL
1. Disconnect harness connector from solenoid (2).
2. Disconnect vapor hoses (1 and 4) from solenoid
(3).
3. Remove solenoid (3) from bracket (5).
EVAPORATIVE EMISSIONS 25 - 17