Chrysler 2005 Crossfire SRT6 Service Manual page 3600

23 - 52 CONVERTIBLE TOP
9610 MAIN CYLINDER TRAVEL SENSOR (ROD SIDE) +/- CIRCUITS OPEN/SHORT
TO GROUND (CONTINUED)
6.
Open Main Cylinder Travel Sensor (Rod Side) (+) circuit
With the ignition on.
Measure the voltage of the Main Cylinder Travel Sensor (Rod Side) (+)
circuit by backprobing from the Power Top Control Module C1 harness
connector.
Is the voltage above 10.0 volts?
Yes >> Repair the Main Cylinder Travel Sensor (Rod Side) (+) cir-
cuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 7
7.
Main Cylinder Travel Sensor (Rod Side) (+) Circuit Shorted to Ground
Turn the ignition off.
Disconnect the Power Top Control Module C1 harness connector.
Measure the resistance between ground and the Main Cylinder Travel
Sensor (Rod Side) (+) circuit.
Is resistance below 100 komhs?
Yes >> Repair the Main Cylinder Travel Sensor (Rod Side) (+) cir-
cuit for a short to ground.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL)
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
ZH