ZH
9915 TRUNK LATCH LOCKED SIGNAL CIRCUIT OPEN (CONTINUED)
3.
Open Trunk Latch Locked circuit
Turn the ignition off.
Disconnect the Power Top Control Module C1 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Trunk Latch Locked signal circuit from
the Trunk Latch Assembly C1 harness connector to the Power Top
Control Module C1 harness connector.
Is the resistance below 5.0 ohms?
Yes
>> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No
>> Repair the Trunk Latch Locked circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL
MODULES/
CONVERTIBLE TOP 23 - 181