Chrysler 2005 Crossfire SRT6 Service Manual page 4287

24 - 158 PLUMBING
1. Evacuate the refrigerant from the system. (Refer to
24 - HEATING & AIR CONDITIONING/PLUMBING
- STANDARD PROCEDURE).
2. Disconnect the electrical connector (2).
3. Remove the upper pressure line (1).
4. Remove the refrigerant pressure sensor (2).
5. Raise and support the vehicle.
6. Remove the wheel and tire assembly.
7. Remove left inner fender (front section) by remov-
ing the plastic nuts and the screws attaching the
panel to the inner fender liner.
8. Remove the pressure line (1).
9. Remove the mounting nuts (2).
10. Remove the receiver/drier from the vehicle.
ZH